eleVENT™ Heater Port System
Dedicated 75mm Window Pass-Through for Diesel Heater Setups
The eleVENT™ Heater Port System is a vehicle-specific front window insert designed specifically for diesel heater use.
Built around a sealed window plate and a dedicated 75mm (3") pass-through port, this system provides a clean, reliable way to route heated air into your vehicle — without modifying your vehicle or relying on heat-sensitive components.
Installation is simple and fully reversible: roll the front window down, place the window plate into the opening, then raise the window to secure the assembly in place.
Estimated lead time: Approximately 2 weeks
Purpose-Built for Heat
Diesel heaters produce sustained high-temperature airflow that requires a dedicated solution.
Unlike modular vent systems, the eleVENT™ Heater Port System uses a sealed plate with a direct pass-through port, eliminating unnecessary openings and reducing heat loss.
What’s Included
Each Heater Port System includes:
- Vehicle-specific window plate (no vent openings)
- Pre-cut 75mm (3") heater port
- Metal mounting flange
- High-temp gasket
- Mounting hardware (nylon lock nuts included)
How It Works
- Heater duct connects directly to the 75mm port
- The sealed plate helps retain heat inside the vehicle
- The system installs on either the driver or passenger side
- No permanent modifications are required
Installation Notes
The Heater Port Kit is user-installed, allowing you to choose which side of the vehicle to configure.
All required hardware is included, and the flange mounts securely using a multi-bolt pattern for consistent sealing and durability.
Compatibility
- Designed for standard 75mm (3") diesel heater ducting
- Compatible with 60mm systems using commonly available reducers
- Works with most portable diesel heater setups
Important Use & Safety Notes
⚠ Driving Use
Never drive with the system installed.
⚠ Heating Systems
Follow all manufacturer safety guidelines. Ensure proper ventilation at all times.
⚠ General
Designed for compatible vehicle windows only. Do not modify or force-fit components.
